Darn 3D-Sloped floor error!

Replica · Post by **Replica** » Fri May 23, 2008 3:57

I really dont get it! I'm not sure what I've done to get error. I wanted to have some instant kill lava flow up this gaint room, and you have to run put the room to the top before the lava gets to the top. Thats were the error is, I get the sloped floors just appear randomly sided and some what height change.

Heres the wad. I took out some Textures and things. Theirs no monsters in yet. An you cannot get to the room by going threw it. You'll have to go to the left and use IDSPISPOPD to get to It. http://files.filefront.com/SLOPEHELPwad ... einfo.html

Post by **Enjay** » Fri May 23, 2008 9:04

Can't check ATM but you're not using glowing flats are you? If so, these don't work properly with slopes.

Replica · Post by **Replica** » Mon May 26, 2008 20:16

No, I'm not using glowing flats. Their just plain grey flats.

Edit = I fixed it.

Post by **Enjay** » Mon May 26, 2008 21:27

By the look of it, it's a classic 3D slope error: ie you have not aligned the problem slope control sectors with the sectors that they will actually appear in when you playe the game. This means they are appearing in funny places or at unwanted heights and overlapping with other architecture.

It's been asked about a few times. Here are a couple of relevant threads.

http://forum.drdteam.org/viewtopic.php?t=2756
http://forum.drdteam.org/viewtopic.php?t=1696

Replica · Post by **Replica** » Tue May 27, 2008 19:43

Thank you for the help

.